[schilytools] cdrecord defaults

[Robert Clausecker]

Hi Friedhelm,

Yes, it is a good idea to comment these out.  I'll push a change with
that soon.

Yours,
Robert Clausecker

Am Mon, Sep 12, 2022 at 10:49:03AM +0200 schrieb Friedhelm Mehnert:
> Hello,
> 
> I have discovered, that the file "cdrecord/cdrecord.dfl", which gets
> installed into "/etc/default/cdrecord", contains the following table at
> the end:
> 
> > # drive name    device          speed   fifosize driveropts     transfersize
> > #
> > my-default=     1,0,0           -1      -1      burnfree        63k
> > sol-default=    USCSI:1,0,0     -1      -1      burnfree
> > ricoh-u=        USCSI:0,2,0     -1      -1      burnfree
> > teac=           1,3,0           -1      -1      ""
> > teac-max-ts=    1,3,0           -1      -1      ""              32k
> > panasonic=      1,4,0           -1      -1      ""
> > plextor=        1,4,0           -1      -1      ""
> > sanyo=          1,4,0           -1      -1      burnfree
> > yamaha=         1,5,0           -1      -1      ""
> > cdrom=          0,6,0           2       1m      ""
> > remote= REMOTE:rscsi at somehost:1,0,0 16  16m     burnfree
> 
> I may be wrong, but I think that this may possibly lead to problems, in
> the rare case, that you have one of those drives on your system, but on
> a different device.  I think, those should be commented out, just to be
> safe.
> 
> 
> Best Regards
> Friedhelm
> 
> -- 
> schilytools mailing list
> schilytools at mlists.in-berlin.de
> https://mlists.in-berlin.de/mailman/listinfo/schilytools-mlists.in-berlin.de

-- 
()  ascii ribbon campaign - for an 8-bit clean world 
/\  - against html email  - against proprietary attachments