linux-l: hda: status timeout: status=0xd0 { Busy }
Holger Paulsen
paulsen at mobile.in-berlin.de
Mo Jun 19 08:38:23 CEST 2000
Wird hier eventuell offtopic sein, vermutlich eine
Hardwaregeschichte, aber sei's drum.
Obige Meldung habe ich recht oft auf der Konsole, wenn die
Festplatte sehr aktiv ist, meist nach einiger Zeit gefolgt
von
hda: no DRQ after issuing WRITE
ide0: reset: success
Tritt auf bei 2.2.10- und 2.2.14-Kernel.
Einige möglicherweise erhellende Informationen:
paulsen:~# hdparm /dev/hda
/dev/hda:
multcount = 0 (off)
I/O support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 0 (off)
keepsettings = 0 (off)
nowerr = 0 (off)
readonly = 0 (off)
readahead = 8 (on)
geometry = 1048/255/63, sectors = 16841664, start = 0
paulsen:~# hdparm -i /dev/hda
/dev/hda:
Model=ST38410A, FwRev=3.20, SerialNo=7DX0ED0M
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs
RotSpdTol>.5% }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
BuffType=0(?), BuffSize=512kB, MaxMultSect=32, MultSect=off
DblWordIO=no, OldPIO=2, DMA=yes, OldDMA=2
CurCHS=16383/16/63, CurSects=16514064, LBA=yes,
LBAsects=16841664
tDMA={min:120,rec:120}, DMA modes: mword0 mword1 mword2
IORDY=on/off, tPIO={min:240,w/IORDY:120}, PIO modes: mode3
mode4
UDMA modes: mode0 mode1 *mode2 mode3 mode4
Holger
Mehr Informationen über die Mailingliste linux-l